Gas and electrical capacity are fundamental considerations when specifying commercial catering equipment. While the primary focus is often on cost, it’s just as essential to get your gas and electrical loads right during the planning process.
Underestimate your requirements, and you risk tripped circuits, inadequate gas supply or equipment that cannot perform at full capacity. Overestimate, and you may pay for capacity you never use. Here we look at how to calculate the loads for your commercial catering equipment before you commit to a new kitchen fit-out, so your supply matches your kitchen from day one.
The calculations below are intended as a planning overview only. Final electrical and gas requirements should be confirmed by appropriately qualified professionals.
Why Load Calculations Are Important For Hotel Kitchens
Every piece of commercial catering equipment, from ovens and griddles to dishwashers and refrigeration, draws a certain amount of power. Add several appliances together across a busy hotel kitchen and the total load can be substantial. Getting an accurate picture before installation helps you plan a supply that can cope with real-world demand, keeps you compliant with safety regulations and avoids costly changes once equipment is already in place and the kitchen is up and running.
Poorly planned loads can also cause problems long after opening day. A hotel that adds new equipment over time, such as an extra combi oven or additional refrigeration for a growing breakfast service, may find the original electrical or gas supply was never designed to cope with the increase. Working out your loads properly from the start makes it far easier to expand later without expensive infrastructure changes.
Working Out Electrical Power Consumption
For electrical equipment, the starting point is the wattage of each appliance, usually shown on a data plate or in the manufacturer specification. For electrical load planning, the rated input of each appliance should be considered alongside its supply type, phase requirements and current demand. Energy consumption and running cost can then be calculated separately using kWh usage and the relevant energy tariff, helping you understand the power consumption of catering equipment.
Keep in mind that not every appliance runs at maximum output at the same time, so maximum demand and diversity may be considered as part of the electrical design. This should be assessed by a competent professional rather than assumed from the total connected load alone, when reviewing the average electrical power consumption of catering equipment.
Calculating Gas Loads
Gas-fired catering equipment is rated in kilowatts too, though the figure refers to heat input rather than electrical draw. Adding together the kW ratings of every gas appliance, from ranges and fryers to combi ovens, gives you the total connected gas load for the kitchen. As with electrical loads, actual demand is usually lower than the total connected figure, since equipment cycles on and off rather than running continuously at full output throughout service.
The total connected gas load forms part of the information needed to assess meter capacity, pipework and the wider gas installation. Ventilation and gas interlock requirements must also be considered by appropriately competent professionals.
A hotel kitchen that expands its equipment list without reviewing its gas supply can quickly run into performance issues, particularly during peak service when multiple appliances are firing at once and demand on the system is at its highest.
Bringing Gas And Electrical Loads Together
Most hotel kitchens run a mix of gas and electrical equipment side by side, which means both calculations need to be considered together rather than in isolation. A kitchen with a strong gas supply but limited electrical capacity, for example, may struggle to run additional refrigeration, extraction or electrical prep equipment without upgrades. Looking at the full picture across both energy types helps avoid these mismatches before they become a problem during a busy service.
Getting Professional Support With Your Kitchen Plan
While the basic formulas above give you a useful starting point, working out precise gas and electrical loads for a full commercial kitchen involves a lot of moving parts. Equipment specifications, simultaneous usage patterns and building supply capacity all need to be factored in together. This is where working with an experienced supplier can make a real difference, helping you avoid costly under- or over-specification and giving you confidence that your kitchen can handle whatever service throws at it.
At Kitchen Solutions, our team can help assess your hotel's equipment list and supply requirements before you invest in new commercial catering equipment. Contact us today to talk through your kitchen project and make sure your gas and electrical loads are calculated correctly from the outset.


